Our original molded rubber comb raiser is molded in black hard rubber with a 2" velcro cinch strap attached for easy application to most classic styled rifles and shotgun stocks. Only available in right hand, this model raises line of sight 1 1/4" above a stocks comb. The hard rubber compound allows you to grind off material if needing a lower height and with different grits of sand paper on a sanding belt or block it can be returned to the original smooth finish. A double sided tape between pad and stock, keeps pad from sliding forward. Can be removed from stock for cleaning the barrel. This model does not lend itself to some long bolt actions where bolt extends back over the comb when cycling the bolt.
Posted by Unknown on 11th Sep 2019
I have 2 of these Accu-Risers and I have yet to find another product to increase comb height that is as well made and easy to install as the Accu Riser. The option of easily swapping this between guns is awesome. Very solid cheek weld and can be complemented with a neoprene stock guard cover to camo it up if you want. Most neoprene covers will fit over this Accu Riser. Awesome product!!!
Posted by Robert Travis on 21st May 2019
It fits my rifle but I'll need to field test it at the range.
Posted by Unknown on 15th Jan 2018
I installed the strap on comb raiser on my Remington 870 slug gun and it fits well and does the job of putting my eye at scope level. Its well made and should last a very long time, but my only complaint is the cost of $38 for a piece of molded rubber with a 2" velcro strap attached. I'm thinking $20 would be the ballpark figure that's the reason for 4 stars.
Posted by Ron Heyde on 14th Aug 2017
Because of a design issue by Henry FIrearms, this riser was necessary to get proper eye relief with a mounted scope. This did the trick nicely.....only thing i wish is that it fit over the stock rather than rest on top....Henry is aware of this problem and has your company name for contact as your product was the best fix for the problem
Posted by Wayne Potts on 12th Aug 2017
This is the second one I bought first was for muzzleloader with high scope mounts second for shotgun used for turkey hunting with red dot I no longer have to lift head of of stock to use optics.Great product
Posted by Rob Peel on 26th Oct 2015
Just installed this riser on an early Marlin 336. The scope, even on low mounts, was forcing my face too high on the comb. This riser gives me a perfect cheekweld with correct eye relief.
Spectacular value for money & super fast shipping.
Posted by Unknown on 16th Jun 2015
I looked at several products and finally decided on this one. It exceeded my expectations and fit my gun stock perfectly.
Posted by Unknown on 28th Jul 2012
Purchased this for a savage 12 bvss in 308. This stock is thicker than the average hunting rifle, but this riser fits ok. Velcro strap gets it nice and snug, but haven't fired it yet to see if it stays in position. My suspicion is that it will slide forward without the tape, but i'm thinking my own velcro on the bottom of the riser should solve that. Had to trim it down a little [I used a bandsaw] then sanded it smooth and then ready go.